Brake & Wheel

Six tools in one for exceptional versatility and value. Kit consists of three forks and two handles; one for hammering, the other for use with an air hammer (.401" shank). All forks are threaded to interchange with either handle. Forks are heavy-duty...

Step Design Helps Keep Tool from Bouncing Back When Separating Ball Joints, Steering Dampeners, Tie Rods, Pitman Arms and Other Applications. Six tools in one. Three forks and two handles. Forks are threaded to interchange with either handle. One handle...

Allows Technician to Remove Parking Brake Cable by Compressing the Spring. Tool can be used when cable is still attached to parking brake assembly. Ends of tool are angled to allow easier access. Slots on each end allow tool to slip over cable instead of...

Removes and installs axle nuts on 4WD axle hubs. Durable, impact-grade heat-treated alloy steel. Extra deep to fit over various axle lengths. Works where standard sockets won't. Use with 1/2" drive. Applications: 2008-2010 Toyota Land Cruiser 2008-2010...

FWD Axle Nut Socket (36mm) For All 36mm Axle Nuts. Durable, impact-grade material. Deep to fit over variable axle length s. Works where standard sockets won't.

Dodge Separates the Frozen Hub Assembly from the Steering Knuckle on Dodge Vehicles. Tool drives against loosened retaining bolts to separate assembly. Prevents damage to the knuckle and complete hub assembly. Tool drives on the bolt flange, so the head...

Quickly Flushes Out Old Grease and Repacks Bearings with Less Mess. The Handy Packer works on bearings up to 3 1/2" O.D. The grease stays in the tool cavity, not on your hands. To pack a bearing, place the bearing on the piston. Press down on the cap...

For Removing and Installing 9mm Hex Brake Caliper Bolts. Used to remove and replace 9mm Hex Brake Caliper Bolts on late model Ford SUV and Mercedes application. May also work on other applications.

Makes Both Single and Double SAE Flares. This tool set includes everything to flare thin wall steel, aluminum or .040 wall soft copper tubing. The set includes 5 thread dies and adapters for forming double flares on the following tubing sizes: 3/16",...

For all ear-type clamps including GM FWD outboard CV joints. Designed for use with a torque wrench, as required for stainless steel bands.

Crimps Ear-Type Clamps in Hard-to-Reach Areas. A special boot clamp crimping pliers that is designed to work in confined spaces. The pliers work from the side (head is turned 90 degrees) unlike traditional tools that work from the end.

A Quick Way to Spread Brake Pads and Compress Disc Brake Pistons for Pad Replacement on Single, Double & Quad Piston Calipers. Simultaneously compress all four pistons on quad piston applications. Can be used while caliper is on the vehicle or...