Pullers

Heavy duty 10 pound Slide Hammer on Steel Shaft reduces effort, time and labor to make a tough job easy Pullers fit 4, 5 and 6 bolt patterns for use on most domestic and imported cars and light trucks Easily removes front wheel hubs and flange type rear...

Separates the front hub from the axle on front wheel drive cars. Can be used with any slide hammer having a 5/8"-18 male thread or the included 5/8"-18 x 5 1/2" long Forcing Screw. Hex Nut makes using with a standard slide hammer easy.

Combination 10 pound Slide Hammer and Hub Puller makes removing axles and hubs easy Comes complete with flanged Pulling Yoke Use to remove front and rear wheel drive axles Can be used to remove flange type rear axles The extra heavy 10 pound weight...

Use with slide hammer to remove rear axles on popular cars and most trucks with flange type axles. The bolt circle range is 41/2½ to 51/2½. Slots permit use on axles with 4, 5 or 6 studs in the circle. Supplied with 5/8½-18 lock nut.

Convert your Cat. Nos. 80000, 81000 & 81100 to a Slide Hammer Axle & Hub Puller. Adapter accepts 5/8½-18 female threaded pulling attachments. Thread onto Slugger shaft or any shaft having a 3/4½ NPSM thread to pull axles and hubs with ease. Solid steel...

Pulls flange-type rear axles and most front-wheel drive hubs Internal and external jaws provide a variety of combinations to pull bearings, gears and seals Two and three way cross blocks and cone provide the perfect jaw configuration for most jobs Set...

New Dowel Pin Puller that extracts Dowels without the use of a slide hammer. Fit the appropriate sized collet over the dowel, tighten the sleeve, Use outer sleeve and nut to extract the dowel. Can be used with air ratchet, or traditional ratchet...

Tool will remove wheel hubs mounted on tapered axles and press fit rear brake drums Can be adjusted by legs to an 8 inch diameter bolt circle Made of alloy steel and drop forged, this heavy duty tool has a center screw 1 inch 14 x 9-inches with a...

This combination set includes our two most popular bearing 'splitters" (2" and 3"), four sets of hex push-puller legs and a bar-type puller head with a 9/16" forcing screw Separator tools are used with bar puller and legs for a wide variety of pulling...