TA 18000 3/8" Rotary Spot Weld Cutter

Good quality tool. It takes getting used to as the tool can skip off the spot weld if too much downward pressure is applied. The rotary blades are fragile/brittle and can break easily when that happens.

It cuts good and I am getting replacement blades now because the odd angles I have to use it at tends to brake teeth.

I found this cutter to be very effective.

I had to remove my core support on my 1996 4-Runner after a deer ran into it, with all of the 40 or so spot welds. Not only did it do the job fast and efficiently it lasted through all of them. I switched it around ( comes with two cutters back to back how cool is that) and it still has life left in it. My drill however does not! I would recommend this to any one and my son is going to get one just to keep in his tool box if he needs one, he's a maintenance tech.

redone fender and cab corners on 1997 Dodge Ram dump Truck, tool worked fine made my life easier Thanks !! The only 1 thing that needs inprovement is tip needs to be sharper !!, or even a small bit .

I am amazed at how fast this cuts. It took no time to cut through many spot welds. I had to use a small drill to set the point because of uneven metal, but once I learned that trick I was finished in a half an hour. Excellent tool. would buy from this company again.

Im doing a floorpan restoration on my Karmann Ghia. I purchased this cutter to make this project a little easier. This cutter works very well. I made cuts on 120 spotwelds and the cutter is still sharp, and I've only used one side so far. I did use WD-40 to keep it cool. I would highly recommend this cutter if you want to power through spotwelds