Hand Tools

200mm & 230mm extra-long wrenches to reach BMW head bolts Models serviced include N52 non-Turbo and N54/N55 Turbo engines Both T50 & T60 Torx® sizes are needed for this job All 1/2” square drive Made in USA

Thin Jaw Bearing remover

For use with puller or slide-hammer Includes Pipe Expander, Slide Hammer, 5 Pullers and 3 Extensions

For prying, scraping, fastener removal & more All 7” / 18cm long with hang hole Bright red color

Special 140mm long T60 Torx® bolt with machined shaft allows proper clearance to service Dual Mass Flywheel Mount Bolts on E39 V8 4.0 & 4.4L w/ standard transmission 1/2” square drive Made in USA

New 8mm & 10mm sizes to service ’09 & up Honda Odyssey & Pilot seat tracks Both sizes required for both driver & front passenger side tracks 1/4” square drive

Sets Cam timing of both cylinder heads Includes Hold Down Tool and Crankshaft Timing Pin

Cam Alignment Tool For 2.0 & 2.3L twin cam turbo engines

For adjusting camshaft position during cylinder head reassembly or setting injection pump timing Works on VW Diesel w/ ALH engine

For locking and positioning camshafts, crankshafts & injection pump sprockets when replacing timing belts Includes setting gauge and 3 different locking pins Services ’04 – ’09 Mazda 3, ’06 – ’10 Mazda 5, ’03 – ’08 Mazda 6, ’05 – ’08 Ford Escape, ’03...

CTA Tools Volvo Cam/Crank Alignment Kit. Commonly used on Volvo 850, 960, S40, S70 & S90. Used for Alignment of Camshafts and Crankshafts. See the instructions linked pdf below for a comparable tool set more information on how to use this...

Holds camshafts in position during timing belt replacement Works on Twin Cam, Quad Cam & Diesel Engines All steel construction for durability