Engine & Battery

OTC Crankshaft Rear Seal Installer Prevent leaks by properly aligning and installing crankshaft rear seals. This seal installer is a two-piece tool that mounts to the crankshaft and places force on both inner and outer seal bodies. Designed to press fit...

Digital Multimeter and Current Clamp Kit Compatible with Autel's MaxiBAS BT608 and BT609 Battery Analysis Tools Measures Voltage, Current and Resistance Includes 400 Amp Clamp Includes Probes and Leads Troubleshoot Electrical System Measures Battery...

4 PC Interchangeable Inner Tie Rod Tool Kit. Covers the widest range of tie rods featuring a new no-tools-necessary design due to the unique finger operated snap-ring Unique design allows user to change cages with no additional tools Covers the widest...

8A 4-Bank Battery Charger Meet the all-new GENIUS2X4 - Similar to our G4, just better. It's 40% smaller and delivers 140% more power. It's the all-in-one 4-bank solution - battery charger, battery maintainer, trickle charger, plus battery desulfator...

Removes and installs fuel injector sleeve cup Saves time by eliminating need to remove heads Services 2008-2010 Ford 6.4L Powerstroke Diesel on F-250, F-350, F-450 & F-550 Also services 2008-2010 Maxxforce 7 Compare to Ford Factory Tools 303-1262...

Removes and installs fuel injector sleeve cup. Saves time by eliminating need to remove heads. Services VT275 24 Valve, VT365 32 Valve, 2006-2009 6.0L Powerstroke Diesel, & 2004-2010 4.5L Diesel, including Low Cab Forward E-Series, F-250, F-350,...

CTA Rear Crankshaft Seal R&I Tool Cummins 3.5L 3.9L 5.9L & 6.7L Removes & installs seals with & without wear sleeves such as: #3934486, #3926126 & #3925529 Services Cummins 3.5L, 3.9L, 5.9L & 6.7L; 1989-2016 Cummins 4BT 3.9L; B...

Multiple-banks- A three-bank on-board battery charger rated at 15-amps (5-amps per bank) for 12-volt batteries, including marine, boat, starter, and deep-cycle batteries. Independently charge and control each battery bank with selectable charging modes...

A sturdy, sealed 6.0L (1.5 Gal) reservoir and common adapter hoses designed to handle transmission fluid. A single valve controls fluid flow to extract or dispense transmission fluid. The universal adapter accommodates most domestic vehicles with...

Ensure replacement injectors and seals are installed correctly. This kit installs the dual seals onto the end of the injector. These seals must be installed into their grooves, and then sized to the engineered dimension before the injectors are installed...

Used for holding the crankshaft & camshafts when removing & installing timing components. Sets the engine in the proper position in order to perform engine service. Included components: Camshaft locking blocks, Flywheel locking pins, Timing...

OTC GM Injector Seal Installer and Sizer Adapters Ensure replacement injectors and seals are installed correctly. This kit installs the Teflon seal onto the end of the injector. The pilot cone is placed onto the end of the injector and the seal is...