Brake & Wheel

Makes changing pads an easy job. Tool compresses disc brake piston for easy pad installation.

Squeeze the handle and the fast acting plunger compresses disc brake pistons in seconds. Makes brake pad replacement an easy job.

STONE SET 220 GRIT FOR LS23500

Quickly Removes the U-Joint Cap from the Drive Shaft on Most Rear Wheel Drive Vehicles. Use the driver with an air hammer to remove u-joint caps up to 1-5/16" diameter. Prevents damage to drive shaft and axle shaft ears, when presses or chisels are used...

Stepped design helps keep tool from bouncing back. The 18530 is used to replace worn out ball joints and to remove CV drive shafts on FWD vehicles. The tine opening is 15/16". These heavy-duty tools are drop forged and heat-treated for long use. Steps...

Stepped design helps keep tool from bouncing back. 18520 is used to replace worn out tie rods and to separate shock absorber links. The tine opening is 11/16". These heavy-duty tools are drop forged and heat-treated for long use. Steps can be sharpened...

The pipe stretcher kit is a convenient, inexpensive alternative to hydraulic pipe expanders. Comes in a molded storage case. Stretches Pipe up to 4-1/4" Including Stainless Steel. Use with an impact wrench to quickly stretch pipes. Collet sets expand...

500 GRIT STONE SET FOR 15000

Makes it Easier to Insert Wheel Bearing Race and Seals Without Damage to Race and Axle Housing. This master set includes nine drivers to fit most common wheel bearings. Turn discs over to drive seals. In convenient clam shell for storage.

This set also includes 2 handles, one for hammering and a pneumatic handle for use with an air hammer. Use the tapered driver side for bearing races; reverse to the flat side for seals. Sizes: 1.565, 1.750, 1.965, 2.325, 2.555, 2.830, 2.995, 2.470, 4...

Brake Spring Pliers Double Ended Tool for Removing and Installing Brake Springs. Use plier tips to stretch brake spring. Handle ends remove and install spring over anchor post. 11260, brake, brakes, spring, pliers

Brake Bleeder Wrenches 1/4" x 3/8" Wrench for Bleeding Air From Brake Cylinders With Bleeder Screws. Double ended tools are offset for easy access. For 10950 for 1/4" or 3/8" bleeder screws. 10950, brake, brakes, bleeder