Brake & Wheel

Brake Bleeder Wrenches 5/16" x 3/8" Wrench for Bleeding Air From Brake Cylinders With Bleeder Screws. Brake Bleeder Wrenches 5/16" x 3/8" Wrench for Bleeding Air From Brake Cylinders With Bleeder Screws. Double ended tools are offset for easy access...

Controlled pressure makes it possible to polish or hone with just one stone grit. Square ends of stones hone to the end in step-cut and blind-end cylinders. 240 grit stones are 1 1/8" long. Flexible driver.

Special abrasive pads polish the cylinder without cutting. Controlled pressure, three abrasives and flexible driver give good stability and speed. Stones are 1" long.

STONE SET FOR LS10000

Brake Cylinder Hone 3-Stone Hone Fits Cylinders 27/32" to 2" (21.4-50.8mm). Brake Cylinder Hone 3-Stone Hone Fits Cylinders 27/32" to 2" (21.4-50.8mm). Controlled pressure makes it possible to polish or hone with just one stone grit. Square ends of...

Adjustable with special replaceable forged jaws. Two clamp bolts lock jaws on Pitman arm. Can perform other pulling jobs. Services cars and light trucks to 3/4-ton.

This puller is designed for the toughest Pitman arm jobs. They’re adjustable and have rugged forged jaws shaped to fit the job. Two clamp bolts lock the jaws on the Pitman arm, ensuring a solid grip. Includes an adapter for added versatility. Both...

These devices quickly and easily compress most sizes of MacPherson strut springs. Setup is fast and simple. Compression is achieved by alternating from one assembly to another. Each device has a heat-treated alloy thrust screw (5/8"–11 x 12") with forged...

For use with 1985-newer Ford F-series 3/4 and 1 ton truck with Dana 80 Rear axle

C-Frame press, 3 receiver tubes, removal and installation adaptors. # Removes and installs press-fit parts such as ball joints, universal joints, and truck brake anchor pins. # Contains: 3 receiver tubes (2-3/4" I.D. x 3" O.D., 2-1/4" I.D. x 2-1/2" O.D.,...

Removes front hubs without damaging the wheel bearing. Its universal design fits most FWD cars. The spare locknut lets you use it with a standard slide hammer puller for rear axle flanges.

Designed for installing wheel bearing cups of tractor/trailer wheels from 11000 to 50000 lb. capacity. A Adjust and lock the jaws to the cup I.D., slip on the new cup, put it all in place, then hit the handle with a hammer. Adjusts from 3 5/8" to 6 1/2"...